Description
Product: Intelligent Temperature Sensor
Instruction manual:
Code Code Description Setting Range Factory settings
P0 Cooling/Heating C/H C
P1 Hysteresis setting 0.1-50 2
P2 Max setting value 120 120
P3 Min setting value -55 -55
P4 Temperature correction -10.0~10.0Degree Celsius 0
P5 Delay start time 0-10 minutes 0
P6 High temperature alarm -55~120 Off
P7 Data lock switch On/off Off
P8 Restore factory settings On/off Off
P0:Cooling/Heating mode
High temperature start cooling mode:C
low temperature start heating mode:H
P1:Hysteresis setting
heating mode(H):measured value<=set value – hysteresis start output heated to set value to stop
cooling mode(C):measured value>=set value – hysteresis start output cooled to set value to stop
P2:Max setting value
the setting maximum temperature does not exceed this value
P3:Min setting value
the setting minimum temperature does not lower than this value
P4:Temperature correction
When measuring the temperature and the standard deviation of temperature, you can use this function to correct.Corrected temperature = Temperature before correction + Correction value
P5:Delay start time (minute)
P6:High temperature alarm
When the measured temperature exceed this value,the screen will flash and send out warning beeps,at the same time forced turn off output.
P7:Data lock switch
Turn on the data lock switch,can keep the current setting is not altered.If you need to alter,please turn off the data lock switch.
P8:Restore factory settings
Long press SET button to swith P8,and press SET button again,set to on,then press RST button to restore factory settings.
